Assuming that I have a installed and working FSG 60M tray in my panel,
what Dittel radios, if any, are a slide-in upgrade replacement?

Regards,
Ken

Hi Ken,

It is my understanding that no two models of Dittel radios are wired the
same. So re-wiring of the DB connector is likely necessary. However, the
existing speaker and microphone should work fine with a newer Walter Dittel
radio.

Best Regards,

Paul Remde
Cumulus Soaring, Inc.

"kenward1000" > wrote in message
...
> Assuming that I have a installed and working FSG 60M tray in my panel,
> what Dittel radios, if any, are a slide-in upgrade replacement?
>
> Regards,
> Ken

On Dec 2, 7:38*pm, "Paul Remde" > wrote:
> Hi Ken,
>
> It is my understanding that no two models of Dittel radios are wired the
> same. *So re-wiring of the DB connector is likely necessary. *However, the
> existing speaker and microphone should work fine with a newer Walter Dittel
> radio.
>
> Best Regards,
>
> Paul Remde
> Cumulus Soaring, Inc.
>
> "kenward1000" > wrote in message
>
> ...
>
> > Assuming that I have a installed and working FSG 60M tray in my panel,
> > what Dittel radios, if any, are a slide-in upgrade replacement?
>
> > Regards,
> > Ken
>
>

Or while at it just buy the new Becker AR6401 (not sure if they are
shipping yet, but if it was me I'd hold out...).


Darryl

Only the FSG40, FSG50 and FSG60 use the same type connector and are tray
mounted radios..all were excellent radios but alas they are getting older
and parts may become an issue. You will however use the same component parts
and Microphone, Speakers ect are all compatible with newer Walter Dittel
radios so you can leave all of your wiring in the glider and just if you
like snip it off at the radio trailer and make a short pigtail for whatever
new radio you want to install and use a terminal strip or similar connector
to attach your existing wiring to the new pigtail. The only issue you might
run into if installing a different radio brand like a Microair, Xcom or
Flightline radio is that these do not accept the non-amplified Dynamic
microphones that you "might" have now....might have because the Walter
Dittel radio could be set up to use either amplified or non-amplified
microphones, in which case you can still use your existing Microphone but
will need an added amplifier, (I also have these) so you can choose almost
any replacement radio and make the swap with relative low cost and
ease..just add an adapter plate to change the panel from the square opening
to small round opening and splice the harness and you're done
see my website for all radio and installation options
best regards
Tim Mara
Please visit the Wings & Wheels website at www.wingsandwheels.com

"kenward1000" > wrote in message
...
> Assuming that I have a installed and working FSG 60M tray in my panel,
> what Dittel radios, if any, are a slide-in upgrade replacement?
>
> Regards,
> Ken
>
> __________ Information from ESET NOD32 Antivirus, version of virus
> signature database 5672 (20101203) __________
>
> The message was checked by ESET NOD32 Antivirus.
>
> http://www.eset.com
>
>
>



__________ Information from ESET NOD32 Antivirus, version of virus signature database 5672 (20101203) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com